
Tyres tend to get punctured when you are the least prepared. That used to be a big problem with tubed tyres, which would run out of air immediately. But the tubeless tyres make things a bit more relaxed. Since there is no tube, the leakage occurs at a slow rate, allowing you to reach a safe spot. Once you park your vehicle, it is time to figure out what to do with the tyre puncture.
In general, when it comes to tyre punctures, you have three options. You can drive your car to the nearest garage to get the leak fixed. You can also call a mobile tyre repairing service or tow service. Or, you can take matters into your own hands. In this article, we will focus on the third alternative. That way, you will be able to fix a punctured tyre quickly and efficiently without needing any help. Besides, punctures on tubeless Performance Tyres London are easy to repair. So, even if this is your first time getting your hands dirty, you will be fine.
There are five steps to this repair process. Let us go through each of them carefully.
Step 1 – A Tubeless Tyre Puncture Repair Kit may help:
Before you start fixing anything, you have to have the right equipment to do it. So, buy a tubeless tyre puncture fixing kit. You can find them at almost every vehicle accessories store. Tyre dealerships sell them as well. If you prefer shopping online, you can get one from a marketplace. Aside from this kit, you will also need a tyre inflator and pliers. You can get both of these items online or at a hardware store. Keep all these supplies in the car trunk. That way, you will be able to use them anytime one of your tyres has a puncture.
Step 2 – Halt Carefully In A Safe Area:
While the previous step was preparatory, the main work starts from this one. Typically, a bumpy ride or a blinking tyre pressure monitoring system (TPMS) alert should let you know about a leak. So, if you find your tyre has a puncture while driving, the first task is to stop at a secure location. That area has to be well-lit and, of course, away from incoming traffic.
Step 3 – Assess The Level Of Damage:
Before you start repairing, you need to locate the damaged area and understand its severity. That will vary on a case-by-case basis, and so will the repair method. Regardless, start by checking whether the puncture is in the front or rear tyre. If it is in the front one, you are in luck. That is because it does not have to be dismounted during repairs. Turning the wheel after finding the puncture area works just fine. But if the puncture is in the rear wheel, the vehicle will need to be elevated using a jack. Then the wheel shall be removed.
Step 4 – Bring Out The Tubeless Tyre Puncture Repair Kit:
Once you find the puncture, irrespective of whether it is on the front or rear wheel, you will have to use the kit the same way. With the help of the smoothening instrument and a pair of pliers, dislodge the sharp object from the rubber. Using the same tool, smooth out the perforation. Allow it to enlarge until the rubber piece can fit it perfectly. Insert it inside with the strip insertion instrument before pulling it out.
Step 5 – Assess Your Work:
Once you successfully clog the hole, most of your work is done. Sometimes, a bit of the rubber piece might stick out from the tyre, which you can snip right off with a blade. It is also worth mentioning that you should not use a kit, which is past its expiry date or older than two years. It will be really difficult to insert the rubber strip, and you might end up damaging the surrounding rubber.
Tyre punctures are common, and it is not much you can do to avoid them. While maintenance can be a little helpful, it cannot prevent you from driving over nearly invisible sharp objects on the road. So, if you find a leak in one or more of your Car Tyres London, the above knowledge will come in handy. But remember, your safety is of utmost importance. So, be very careful while performing any repairs on your tyres.